Overseeding the Lawn

Healthy, dense lawns are attractive additions to home landscapes. Lawns in poor condition, however, have a negative impact on the landscape. The poor condition of a lawn may be due to poor management, heat, drought, diseases, insects, or other factors. In severe cases, the existing lawn may have to be destroyed and a new one established on the site. Other lawns (those where desirable turfgrasses comprise more than 50% of the lawn) can often be improved by overseeding.

Overseeding is the sowing of grass seed into an existing lawn. In Iowa, the best time to overseed a lawn is late summer (mid-August to mid-September).

Site Preparation

Good site preparation is necessary for successful overseeding. If possible, identify and correct the problems causing the lawn to decline. Overseeding may only be a temporary solution if the problems are not corrected.

To reduce the competition from the established turfgrass, mow the lawn at a height of 1 1/2 to 2 inches. Successful overseeding also requires good seed-to-soil contact. Simply throwing or broadcasting seed over the lawn typically results in poor seed germination as much of the seed rests on the thatch layer or soil surface. Rakes, core aerators, vertical mowers, and slit seeders can be used to insure good seed-to-soil contact.

Overseeding Small Areas

Small areas can be prepared by gently raking the thin spots. When raking, its necessary to break the soil surface by pulling out the existing turfgrass. Sow the seed by hand. Then, work the seed into the soil by gently raking the areas a second time.

Overseeding Large Areas

Large areas can be prepared by using a core aerator. Core aerators are machines with hollow metal tubes or tines. They remove plugs of soil when run over the lawn. To prepare the site, go over the lawn 3 or 4 times with the core aerator. When finished, there should be 20 to 40 holes per square foot. Apply the seed with a drop seeder. Afterwards, drag the area with a piece of chain link fence or drag mat to break up the soil cores and mix the seed into the soil.

It's also possible to prepare the site with a vertical mower. When running over the lawn, the knife-like blades of the vertical mower slice through the thatch and penetrate into the upper 1/4 to 1/2 inch of soil. One or two passes should be sufficient. Afterwards, remove any dislodged debris from the lawn. Sow grass seed over the lawn with a drop seeder. Work the seed into the soil by again going over the site with the vertical mower.

Large areas can also be overseeded with a slit seeder. A slit seeder makes small grooves in the soil and deposits the seed directly into the slits.

Core aerators, vertical mowers, and slit seeders can be rented at many garden centers and rental agencies. If you would rather not do the work yourself, many professional lawn care companies can overseed your lawn.

Post Seeding Care

Keep the seedbed moist with frequent, light applications of water. It's usually necessary to water at least once or twice a day. Continue to mow the lawn at a height of 1 1/2 to 2 inches. Mow the lawn frequently to reduce the competition from the established turfgrass. When you begin to mow the new seedlings, gradually increase the mowing height over the next several weeks. The final mowing height should be 3 to 3 1/2 inches. Approximately 6 weeks after germination, fertilize the lawn by applying 1 pound of actual nitrogen per 1,000 square feet.

Category: 

Links to this article are strongly encouraged, and this article may be republished without further permission if published as written and if credit is given to the author, Horticulture and Home Pest News, and Iowa State University Extension and Outreach. If this article is to be used in any other manner, permission from the author is required. This article was originally published on July 13, 2005. The information contained within may not be the most current and accurate depending on when it is accessed.